View Single Post
  #10  
Old 17th June 2017, 11:17 PM
Glenn Stewart Glenn Stewart is offline
Member
 
Join Date: Apr 2008
Posts: 20
Default

Check your Device Output
  1. Go to your Resin page
  2. Click on your application
  3. Note the device and the column "IP Address" - write down this "IP Address" - we'll use it later.
  4. Click on you device
  5. Wait for status to go from "Downloading" to "Online"
  6. Continue on with the feeders as follows.


Setting up Flightaware for First time
  • Open a browser on the same network as your device (this is a requirement for the very first time only)
  • Go to https://flightaware.com/adsb/piaware/claim (requires you to login)
  • On the list, find your new, now active device. It will be obvious from the date and time and the IP Address should match what you copied above.
  • Claim the new device, although it might also be listed under "Linked PiAware Receivers". Copy the very long text id like abcdefg-1234-6789-a467-879238479283. That's your PIAWARE_ID.
  • As per instructions above insert this into your device variables as PIAWARE_ID = <the gibberish you see on your claim page as above>
  • Resin will automatically reboot your device and it will start using this ID.
  • Click on "My ADSB" and the top of Flightaware.
  • You should see a new "Site". Click on this listing.
  • Click on the cog on the right side of this window. Like this:
  • Change your "Nearest Airport"
  • Configure your "Location" using the GPS co-ordinates recorded a while ago (you can find them in Resin)
  • Configure your "Height"
  • Your done! You won't need to touch this again.
Reply With Quote