17th June 2017, 11:17 PM
|
Member
|
|
Join Date: Apr 2008
Posts: 20
|
|
Check your Device Output
- Go to your Resin page
- Click on your application
- Note the device and the column "IP Address" - write down this "IP Address" - we'll use it later.
- Click on you device
- Wait for status to go from "Downloading" to "Online"
- Continue on with the feeders as follows.
Setting up Flightaware for First time
- Open a browser on the same network as your device (this is a requirement for the very first time only)
- Go to https://flightaware.com/adsb/piaware/claim (requires you to login)
- On the list, find your new, now active device. It will be obvious from the date and time and the IP Address should match what you copied above.
- Claim the new device, although it might also be listed under "Linked PiAware Receivers". Copy the very long text id like abcdefg-1234-6789-a467-879238479283. That's your PIAWARE_ID.
- As per instructions above insert this into your device variables as PIAWARE_ID = <the gibberish you see on your claim page as above>
- Resin will automatically reboot your device and it will start using this ID.
- Click on "My ADSB" and the top of Flightaware.
- You should see a new "Site". Click on this listing.
- Click on the cog on the right side of this window. Like this:
- Change your "Nearest Airport"
- Configure your "Location" using the GPS co-ordinates recorded a while ago (you can find them in Resin)
- Configure your "Height"
- Your done! You won't need to touch this again.
|